Use and Care Manual

Programming Your Code(s)

Three code options:

Factory code: The safe will ALWAYS unlock using this 5 digit

code (found on the back of this owner’s manual). This code

cannot be deleted.

Manager code: a 4-8 digit programmable code of your

choosing that can be changed or deleted.

Secondary code: If you wish to give someone else temporary

access to the safe, you can program a 4-8 digit secondary code

that can be changed or deleted.

NOTE: •Remember,onceyouhavedecidedonyouraccesscodes,opentheunitrstthentestit

with the door open.

 •Allzerosisaninvalidcode.

 •Toturnthebeeperonoroff,pressthe“0”keyandthenthe“Prog/Enter>>”key.

ONLY 1 CODE CAN BE PROGRAMMED AT A TIME

To ADD a manager code:

A. Press the “Prog/Enter>>” key

B. Enter the 5 digit factory code and press “Prog/Enter>>” key.

C. An empty box icon ( ) means no manager code is currently

programmed. A box with a star ( ) means a manager code

is currently programmed.

D. Enter a 4-8 digit code and press “Prog/Enter>>” key to

ﬁnish programming the code into the unit.

To DELETE a manager code:

A. Press the “Prog/Enter>>” key, then enter the 5-digit factory

code and then press the “Prog/Enter>>” key.

B. A box with a star ( ) indicates there is a code programmed

and can be deleted.

C. Enter 0, 0, 0, 0, 0 then the “Prog/Enter>>” key to delete the

manager code.

Programming information

Programming the manager code