Use and Care Manual

10
Bolting Down Your Safe
Bolt down kit contents (in select models only):
• 2Lagscrews.
• 2Washers.
• 2Masonryanchors.
Tools needed to bolt safe to the floor:
• Drill.
• Wrench.
•
7
⁄
16
" (11 mm) drill bit – for drilling into the safe.
•
9
⁄
32
" (7.2 mm) drill bit – for drilling into a wood floor.
•
3
⁄
8
" (9.5 mm) drill bit – for drilling into a masonry floor.
Warning: •DONOTdrillthroughboltcups.
 •DONOTboltthroughthewalls.
 •DONOTdrillfromanylocationinsidethesafe.
1
Tip the safe onto its left side (door hinges horizontal with the floor).
2
Unlock the safe, and open the door. Look to the bottom of the
safe for two indentations on the feet in opposite corners. Using
the
7
⁄
16
" (11 mm) bit, drill a hole through each indentation
perpendicular to the bottom of the safe. Do NOT drill from
any location inside the safe.
3
Tip the safe upright, place the safe in the desired location, and open the door.
4
Use a screw or pencil to mark the floor through both holes.
Bolt down instructions
F
Warning: Product is not water resistant once it is bolted down. The ETL verified water
resistance claim applies to product prior to the application of a bolt-down kit.