Use and Care Manual

12 13
5
Move the safe aside to clear both marked spots for drilling.
6
Drill into the floor:
A
For wood: Using the 9⁄32” drill bit, drill a hole 21⁄2”
(64 mm) deep in each marked spot.
B
For masonry: Using the 3⁄8” drill bit, drill a hole 21⁄2”
(64 mm) deep in each marked spot. Install a masonry
anchor in each hole.
7
Replace the safe in the desired position, with the holes in
the safe aligned with those in the floor.
8
Securing the safe:
A
For wood: Pass each lag screw through a washer,
then through the safe and into a hole. Tighten with
the wrench.
B
For masonry: Pass each lag screw through a washer,
then through the safe and into a masonry anchor.
Tighten with the wrench. Place masonry anchors into
the holes in the floor.
NOTE: The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. Do not drill through the back or sides.
NOTE: Bolting/unbolting the unit is at the consumer’s expense and discretion.
NOTE: Sentry Group is not responsible for any costs incurred if the unit is to be replaced.
For products that do not come with a bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Bolting Down Your Safe Troubleshooting
The Problem: Why it is Happening: The Solution:
The door will not lock Shipping screw is in place Remove the screw on the
back inside of the door
The handle is not in the
horizontal position when
the safe is locked
The clutch mechanism has
been engaged
Rotate the handle up or
down until it clicks into the
horizontal position
Cannot open door after
inputting the electronic
code
Safes doors equipped with
a water resistant gasket
may initially be tight
Hold the handle up while
inputting the code and
then pull down when the
green light comes on
Red indicator light blinks
three times and there
are three beeps
An incorrect code has been
entered
Verify code and re-enter
Red indicator light blinks
five times and there are
five beeps
Please call our Customer
Service center
1-800-828-1438
Red indicator light blinks
once and there is one
beep
Program button is pressed
out of sequence.
-or-
5 seconds has lapsed
between button entries
Start over
Red indicator light is
blinking
An incorrect code has been
entered three times
Wait two minutes and start
over
Yellow indicator light
is on
Battery power is low. The
handle will not open with
this light on
Replace batteries
The dial does not turn Ensure the handle is in the
horizontal position
The handle does not
rotate
Ensure the keylock is in the
unlocked position
Bolt down instructions… continued
F
F
F