Use and Care Manual
4 5
NOTE: Store combination (and keys if equipped) in a secure
location (other than in the safe).
NOTE: Combination can not be changed.
NOTE: SentrySafe offers a secure online location for the entry and
retrieval of your combination. Go to www.sentrysafe.com
and register your safe.
1
Ensure any shipping screws have been removed. Located on
the inside of the door.
2
Find your combination on the back of this owner’s manual.
Warning: Test your combination several times before putting valuables inside.
1
FOR DUAL KEY/COMBINATION LOCKS ONLY, insert key into
the lock, turn to the ‘unlocked’ position, then remove the key.
This is a secondary locking feature not an override key.
Without the key you will not be able to open your safe.
2
Rotate dial to ‘0’, then rotate right (clockwise)
passing ‘0’ three times, continue rotating until you reach the
first number in your combination.
3
Rotate dial to the left (counterclockwise). Go PAST the second
number of your combination ONCE and stop the SECOND time
the dial reaches the number.
4
Rotate the dial to the right (clockwise), stop when you reach
the third number in your combination.
5
Rotate the handle downward to open the door.
This may take a limited amount of force if you have a water
resistant safe.
NOTE: Make sure the handle is in the horizontal position when unlocking the safe.
NOTE: If the door does not open easily, repeat steps 1-5.
NOTE: If you exert too much force on the handle, the handle will move without moving the bolts.
When this happens, you will hear a ‘click.’ DO NOT be alarmed. This feature is designed to
protect the bolts from being over powered by force. If this occurs, simply exert force in the
opposite direction (lifting up) until the handles ‘clicks’ back into place and repeat steps
1-5 to open your safe.
1
Close the door and pull the handle upward until the handle
is horizontal.
For water resistant units, additional pressure to the front,
left side of the door may need to be applied prior to rotating
the handle.
2
Spin the dial at least 2x to the right (clockwise).
3
FOR DUAL KEY/COMBINATION LOCKS ONLY, insert key
into the lock, turn to the ‘locked’ position, then remove the key.
Mechanical Combination Lock
M100TEST
SN100TEST01*
10-22-33
RLR
2075
Preparing your safe for first time use
Locking your safe
Unlocking your safe