Product Manual

6
To ADD a user fingerprint:
1
Press the “PROG” key twice.
2
Enter the 5 digit factory code.
3
The blue light will blink when the system is waiting for a finger swipe.
Swipe your finger in the downward direction over the fingertip sensor.
NOTE: If your finger swipe was accepted, a green light will flash and a beep will sound. If your
finger swipe was not accepted, a red light will flash and a low beep tone will sound.
4
Five to ten accurate reads of the fingerprint are necessary for successful enrollment.
Successful enrollment occurs when the green light flashes three times and three
beeps are heard. Once this happens, you can swipe a second finger if you wish to
enroll two fingerprints.
5
If enrollment is unsuccessful, the red light will flash three times and three low beep
tones are heard. The system will then shut down and you should repeat steps 1-4.
To DELETE a user fingerprint:
1
Press the “PROG” key twice.
2
Enter the 5 digit factory code.
3
Press the “CLEAR” button.
NOTE: The biometric lock asks for two fingerprints when programming a user fingerprint. If you
would like to only use one, allow for lock to timeout or press the “CLEAR” button.
NOTE: You are allowed 10 errors when enrolling a fingerprint – if you cannot enroll a finger in
that time, the system will flash a red light three times, beep three times, and shut down.
Try enrolling again by repeating steps 1-4.
Programming a Fingerprint
Programming your fingerprint
(2 fingerprints allowed per person using the safe)
Programming a secondary code and fingerprint
(2 fingerprints allowed per person using the safe)
NOTE: Make sure the handle is in the horizontal position before entering your code or unlocking
with your fingerprint.
NOTE: Key lock must be in the unlocked position, signified by the lock cylinder being popped out.
1
Press the “CLEAR” button to first awaken your safe.
Unlocking your safe using a fingerprint