Product Manual

10
Bolting Down Your Safe
WARNING: DO NOT drill through bolt cups.
WARNING: DO NOT bolt through the walls.
WARNING: Do NOT drill from any location inside the safe.
Bolt down kit contents (in select models only):
• 2 lag screws.
• 2 washers.
• 2 masonry anchors.
Tools needed to bolt safe to the floor:
• Drill.
• Wrench.
•
7
⁄
16
” (11 mm) drill bit – for drilling into the safe.
•
9
⁄
32
” (7.2 mm) drill bit – for drilling into a wood floor.
•
3
⁄
8
” (9.5 mm) drill bit – for drilling into a masonry floor.
1
Close the door. Tip the safe onto its left side (door hinges horizontal with the floor).
2
Look to the bottom of the safe for two indentations on the feet
in opposite corners. Using the
7
⁄
16
” (11 mm) bit; drill a hole
through each indentation perpendicular to the bottom of
the safe. Do NOT drill from any location inside the safe.
3
Tip the safe upright, place the safe in the desired location and open the door.
4
Use a screw or pencil to mark the floor through both holes.
Bolt down instructions
F
F