Use and Care Manual

8 9
English
Bolt-Down Instructions
Troubleshooting
Bolt-Down kit contents:
2 Screws
2 Washers
Tools needed to bolt safe to a surface:
Drill
Wrench
9/32in (7.2 mm) drill bit – for drilling into wood
3/8in (9.5 mm) drill bit – for drilling into masonry
Select a suitable location for your XL Quick Access Pistol Safe. Set the
safe in place, and use the pre-drilled holes provided on the bottom of
the safe to mark the location of the holes to be drilled in the surface.
NOTICE
Do NOT drill from any location inside the safe.
NOTE: This product is intended to be mounted with a horizontal orientation.
Move the XL Quick Access Pistol Safe while you drill the marked holes
in the surface.
Drill the holes in the surface using the appropriate diameter and depth for the type of hardware
and the mounting surface being used.
A
Replace the safe over the newly created holes.
B
Install the screws and washers as required.
NOTICE
Sentry
®
Safe is not responsible for costs incurred if the unit is to be replaced.
Bolting/unbolting the unit is at a consumer’s expense and discretion.
Bolting down your safe
The Problem: Why It Is Happening: The Solution:
Red LED blinks
three times
Incorrect code or fingerprint
has been entered
Verify the code/fingerprint
and re-enter or reprogram
(see page 4-5)
Programming error
Red LED slowly blinks for
two minutes
An incorrect code or
fingerprint has been entered
five times
Wait for two minutes or use
the override key to access
the safe (see page 7)
Red LED blinks once every
ten seconds
Battery power is low Replace with four AA
alkaline batteries (do not
use rechargeable batteries
or any other type of
non-alkaline battery)
(see page 4)
Red LED blinks five times System error: power failure
Cannot open the lid after
entering the code
Batteries have reached
end of life
Lid does not open when
using override key
Gas strut has stopped
working
Use a magnet to open the
lid. Turn the unlocked unit
upside down for lid to open.
Contact SentrySafe Customer
Service for support.
LED interval will not
reprogram
Incorrect code entry Close the lid and follow
Programming Method
for Interior LED Interval
instructions (page 6)