Use and Care Manual
6 7
English
Programming Method for the Interior LED Interval:
- The interior LED light interval is programmable for three different time intervals: 0, 10, or 20 seconds.
- The factory preset interior light interval is 10 seconds.
NOTES:
- Prior to changing the interior LED light interval, reference the chart below (Table 1) and select
your desired electronic time interval. It is important that you select a code in advance, and
understand the keypad sequences.
- The chosen interval setting is stored in non-volatile memory, until changed again using
this method.
- Your registered user code and fingerprints are unaffected by programming or changing the
interior LED light interval.
TABLE 1: Programming the Interior LED Interval
Programming Interior LED Light:
A
Open the safe using your programmed user code, programmed
fingerprint, or override key. Wait the factory preset time interval of
10 seconds for the interior lights to turn off.
B
Hold down any button on the keypad for 3 seconds. The green
LED light will turn on indicating the safe is ready to accept a new
time interval.
C
Press and hold the designated keypad buttons as shown, to set
your desired time interval (Table 1). The green LED light will
flash two times and the interior LEDs will illuminate indicating
successful programming. If the light interval is incorrectly
programmed, a red LED light will flash one time.
Locking and Unlocking Your Safe
Programming Interior LED Light
(QAP2EL and QAP2BEL)
NOTICE
Test your code several times before putting valuables inside.
Close the lid. Once the lid is closed, the safe is securely locked.
NOTE: The override key needs to be in the locked position.
Remove and store in a secure location.
NOTE: When not in use – the safe will go into standby mode. This is
a lower power mode. Pressing a button will end the standby mode.
A
Press any button once to bring the safe out of
standby mode.
B
Enter your programmed user code.
–OR–
Insert the override key into the keyhole and turn clockwise.
–OR–
For Select Biometric Lock Models Only:
A
Press any button once or touch the fingerprint scanner to bring the
safe out of standby mode.
B
Swipe a programmed finger.
Locking your safe
Unlocking your safe
Keypad Keys Interior LED Interval
1 and 2 0 seconds (does not illuminate)
1 and 3 10 seconds
1 and 4 20 seconds
1
1
1
2
2
2
3
3
3
4
4
4
A
A