Use and Care Manual

12 13
English
5
Move the safe aside to clear both marked spots for drilling.
6
Drill into the floor:
A. For wood: Using the
9
⁄
32
” drill bit, drill a hole 2
1
⁄
2
”
(60 mm) deep in each marked spot.
B. For masonry: Using the
1
⁄
2
” drill bit, drill a hole 2
1
⁄
2
”
(60 mm) deep in each marked spot. Install a masonry
anchor in each hole.
7
Replace the safe in the desired position, with the holes in
the safe aligned with those in the floor.
8
Securing the safe:
A. For wood: Pass each lag screw through a washer,
then through the safe and into a hole. Tighten with
the wrench.
B. For masonry: Pass each lag screw through a washer,
then through the safe and into a masonry anchor.
Tighten with the wrench.
NOTE: • The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. DO NOT drill through the back or sides.
• Bolting/unbolting the unit is at the consumer’s expense and discretion.
• SentrySafe / Master Lock is not responsible for any costs incurred if the unit is
to be replaced.
• When bolting down, ensure the gasket washer is facing down.
• If rubber pads are in place, remove them before drilling.
Not all SentrySafe products come with a bolt-down kit.
Please go to www.sentrysafe.com to learn more about the recommended hardware for
your safe.
Bolting Down Your Safe
Bolt-down instructions… continued
F
F
F
Troubleshooting
The Problem: Why it is Happening: The Solution:
The door will not
close and lock.
1. Confirm that there is no
obstruction in the door.
2. Bolted down incorrectly.
1. Remove all items and accessories
from inside the safe. If this resolves
the issue, re-set the accessories and
organize items to properly fit.
2. See pages 11 for proper bolt-down
instructions.
After inputting the
programmable code,
the door does not
open.
1. Battery Power may be low.
2. May be the wrong battery
type.
1. Use override key to open the safe
and replace batteries.
2. Use 9 volt battery to open your safe
and replace the batteries.
Red indicator light
blinks three times
and there are
three beeps.
An incorrect code has been
entered.
Verify code and re-enter. If the pro-
grammable code you are using does
not work then use the factory code. If
successful re-program your program-
mable code.
Red indicator light
blinks five times and
there are five beeps.
Keypad communication error. Please call our Customer Service center.
Red indicator light
blinks once and there
is one beep.
1. Program button is pressed out
of sequence.
2. 5 seconds has lapsed between
button entries.
Start over.
Red indicator light
is blinking.
An incorrect code has been
entered three times and system
has entered delay mode.
Wait two minutes and start over.
Yellow indicator light
is on.
1. Battery power is low.
2. Battery may be the wrong
type.
Replace with new CR123 lithium
batteries.