Use and Care Manual
10 11
English
The safe you have purchased may include a long-last LED interior
light. Not all safes include a light.
The batteries that operate the keypad are the same batteries that
operate the light. If the light in your unit does not turn on, please
change your batteries. Refer to page 9 to change the batteries.
The light will turn on every time you enter your code and will remain
on for 30 seconds. The light duration has three options – off, 30
seconds, and 60 seconds.
To turn the light off:
1
Press “0” on the keypad.
2
Press “P” on the keypad.
3
Press “3” on the keypad.
To turn the light on for 30 seconds:
1
Press “0” on the keypad.
2
Press “P” on the keypad.
3
Press “4” on the keypad.
To turn the light on for 60 seconds:
1
Press “0” on the keypad.
2
Press “P” on the keypad.
3
Press “5” on the keypad.
NOTE: • If the light duration is 60 seconds, the battery life will be reduced at a
faster rate.
For Programmable Electronic Lock Only
The tones of the keypad may be turned on and off depending on user preference.
Turn sound off:
1
Press “O”on the keypad.
2
Press “P” on the keypad.
3
Press “1”on the keypad.
Turn sound on:
1
Press “O”on the keypad.
2
Press “P” on the keypad.
3
Press “2”on the keypad.
Operating Light/Sound Features
Operating sound features
Bolting Down Your Safe
Bolt-down instructions
Bolt-down kit contents (in select models only):
• 2 lag screws
• 2 gasket washers
• 2 masonry anchors
Tools needed to bolt safe to the floor:
• Drill
• Wrench
•
7
⁄
16
” (11 mm) drill bit – for drilling into the safe
•
9
⁄
32
” (7 mm) drill bit – for drilling into a wood floor
•
1
⁄
2
” (13 mm) drill bit – for drilling into a masonry floor
Warning: • DO NOT drill from any location inside the safe.
• DO NOT bolt through the walls.
1
Tip the safe onto its right side (door hinges horizontal with
the floor).
2
Unlock the safe and open the door. Turn the safe on its side so
the bottom of the safe is accessible. Using the 7/16” (11mm)
bit; drill a hole through two perpendicular feet on the bottom of
the safe. DO NOT drill from any location inside the safe.
3
Tip the safe upright, place the safe in the desired location
and open the door.
4
Use a screw or pencil to mark the floor through both holes.
F
F
How to operate the light