Use and Care Manual

8 9
English
3
The light will flash green and then you will have five seconds to enter your own
personal 5 digit secondary code.
4
Repeat steps 1-3 in order to add an additional secondary code.
To DELETE a secondary code:
1
Press “P” on the keypad two time.
2
Enter the 5 digit user code.
3
Enter 0,0,0,0,0.
4
Repeat steps 1-3 in order to delete an additional secondary code.
NOTE: • The electronic lock will NOT indicate that it has deleted the secondary code – please
test the code to make sure it has been deleted.
• Secondary codes will be deleted in the order they were programmed.
1
Locate the battery pack compartment on the inside of the door
and remove the cover.
2
Insert two CR123 lithium batteries.
3
Replace battery pack cover.
NOTE: • Do not use rechargeable batteries or any other type
of non- CR123 lithium battery. Do not mix old and
new batteries.
If battery power in the safe is running low and cannot operate the safe, you will need to use the
battery auxiliary override feature to open the safe.
IMPORTANT: This should not be used as a primary means to gain entry into the safe.
1
Open the silicone cap found on the side of the lock.
2
Pull out the wire inside the lock and attach a 9 volt battery.
3
Enter your five digit code.
4
Pull handle outward to open the door.
Three code options:
Factory code:
The safe will ALWAYS unlock using this 5 digit code (found on the
back of the owner’s manual). This code cannot be deleted.
User code:
A 5 digit programmable code of your choosing that can be changed
or deleted.
Secondary code:
Up to 3 secondary 5 digit programmable codes can be changed or
deleted. A secondary can only be programmed after a user code
has been activated.
NOTE: • The “C” key is a clear key. This can be used at anytime to clear the system and return to
standby mode – unless you are in delay mode (3 consecutive invalid entries).
• The 5 digit factory code cannot be deleted. However, you may add and delete
additional codes.
This safe can store up to five codes at one time. One factory code and 4 additional
programmable codes.
Programmable Electronic Lock
Programming information
Programming the user code
Programming the secondary code
Battery auxiliary override
To ADD a user code:
1
Press “P” on the keypad.
2
Enter the 5 digit factory code found on the back of your owner’s manual.
3
The light will flash green and then you will have five seconds to enter your own
personal 5 digit user code.
To DELETE a user code:
1
Press “P” on the keypad.
2
Enter the 5 digit factory code.
3
Enter 0,0,0,0,0.
NOTE: • The electronic lock will NOT indicate that it has deleted the user code – please test the
code to make sure it has been deleted.
To ADD a secondary code:
1
Press “P” on the keypad two time.
2
Enter the 5 digit user code previously programmed.
Changing your batteries