Use and Care Manual

6 7
English
1
Enter the 5 digit factory code found on the back of the
owner’s manual.
2
The green light will stay illuminated
to indicate the code is
correct. You will have 5 seconds to open your safe.
3
Pull handle outward to open the door.
NOTE: • Factory installed batteries included.
• Delay mode will occur if three consecutive invalid entries have been tried. Red LED will
blink on and off to let you know the safe is in delay mode. This will cause the system to
shutdown for two minutes. DO NOT remove the batteries to restart the system it will only
increase the length of time for the system shutdown.
1
Close the door to re-engage locking bolts.
2
Turn key to the ‘locked’ position.
1
Close the door to re-engage locking bolts.
2
Wait 5 seconds and try to open your safe without entering any
code or using the override key to ensure safe is locked.
NOTE: • If your safe does not appear to be working properly, please check to make sure you are
using NEW CR123 lithium batteries before contacting customer Service.
NOTE: • Store code (and keys if equipped) in a secure location
(other than in the safe).
• DO NOT RETURN! Questions or concerns, call us at
1-800-828-1438.
Find your code on the back of this owner’s manual.
FOR SAFES WITH OVERRIDE KEY ONLY
Keys are shipped outside of the safe. Be sure to locate them before
locking your safe.
WARNING
Test your code several times before putting valuables inside.
1
Insert key into the cylinder, turn to the ‘unlocked’ position.
2
Pull handle outward to open the door.
Programmable Electronic Lock
Preparing your safe for first time use
Unlocking your safe using the override key only (for select models)
FPW082TEST
SN100TEST01*
12345
Locking your safe using the override key only (for select models)
Unlocking your safe using the electronic keypad
Locking your safe using the electronic keypad