User`s manual

Preset

Run

Type the Preset Point number into the Preset field, click on the button,

and

the

camera will turn to the appointed point.

2.5.2 Sequence

The Sequence Setting can be found under this path: Pan Tilt> Sequence.

The Sequence function supports totally eight Sequence Lines; each Sequence

Line consists of up to 64 Preset Points. Please refer to the instructions below to

program a Sequence Line.

NOTE: Before setting this function, users must pre-define at least two

Preset Points.

Sequence

Setting

 Sequence Line

Please select the number of Sequence Line to be set from the

drop-down list.

 Sequential Preset Points Setting

Please setup each Preset Point of the programmed Sequence Line in

order, assigning a Preset Point from the “NO” list for the specified

number of Preset Point and entering Dwell Time (0~255 sec.) into the

corresponding fields.

 Sequence Reset

To reset the sequence setting of each line, please click on the <Reset>

button in the right top corner of the setup page. And then click on the

<Set> button on the left to refresh the page in order to enter the new

settings.

When finishing the sequential Preset Points setting, please click on the

button <Save> in the top of the Sequence setting menu.

Sequence

Run

Select the specified Sequence Line from the drop-down list, click on the

button, and then the camera will start moving forward each scene sequentially

as programmed.