User`s manual

2.5 Pan Tilt

Under the tab <Pan Tilt>, there are submenus including: <Preset>,

<Sequence>, and <Pan/ Tilt Control>.

NOTE: Pan Tilt function is only available for 10x/ 18x Zoom AF IS-

IP290 and Box Camera (DC12V/ AC24V/PoE Model).

With RS-485 support, the IS-IP290 is capable of working with a Pan Tilt Head

for pan and tilt control. Before implementing pan/tilt control, please ensure the

Pan & Tilt Head is correctly connected to the IS-IP290’s RS-485 port.

Definition

for

IS-IP290’s

RS-485

Port

2.5.1 Preset

6. D－

7. D＋

The Preset Setting can be found under this path: Pan Tilt> Preset.

NOTE: Before setting this function, users must enable the Pan/ Tilt

Control first. Please refer to Pan/ Tilt Control for more details.

There are up to 127 preset points that can be set in the Preset setup page.

Please follow the steps below to set and run preset points.

Preset

Points

Setup

Step 1. Move the camera to the desired position by moving the mouse cursor

onto the screen, one left click on mouse, and then dragging the red

arrow to pan/tilt. Users may adjust the zoom position as well.

Step 2. Once a Preset Point is defined, please assign a number (between 1

and 127) and enter it into the input field.

Step 3. Click on the <√> button to save the defined preset point.