User`s manual

Check the box <Continue image upload> to upload the triggered images

during certain time or keep uploading until the trigger is off. Select

<Upload for sec> and enter the duration in the blank. The images of

the duration will be uploading by E-mail when the alarm input is

triggered. The setting range is from 1 to 9999 seconds. Select <Upload

during the trigger active> to make the images keep being uploaded to

E-mail during the trigger active until the alarm is released. Set the Image

frequency as the upload frame rate. The setting range is from 1 frame to

15 frames.

NOTE: Make sure SMTP configuration has been completed.

Refer to Mail for further details.

 Send HTTP notification

Check this item, select the destination HTTP address, and specify the

parameters for event notifications by <Alarm> triggered. When an alarm

is triggered, the notification can be sent to the specified HTTP server.

For instance, if the custom parameter is set as” action=1&group=2”, and

the HTTP server name is”

http://192.168.0.1/admin.php”,

the notification

will be sent to HTTP server as” http://192.168.0.1/admin.php?

action=1&group=2” when alarm is triggered.

 Record Stream to SD Card

Select the item and the alarm-triggered recording will be saved into your

Micro SD card.

Pre-trigger buffer recording function allows users to check what

happened to cause the trigger. The pre-trigger buffer time range is from

1 to 3 seconds.

Select <Upload for sec> to set the recording duration after alarm is

triggered. The setting range is from 1 to 99999 seconds.

Select <Upload during the trigger active> to record the triggered video

until the trigger is off.

NOTE: Please make sure the local recording (with Micro SD/

SDHC card) is activated so that this function can be

implemented. Refer to Recording for further details.