User`s manual

2.2.8 Application (Compact Fixed Dome Excluded)

The Application setting can be found under this path: System> Application.

The IS-IP290 equips one alarm input and one relay output for cooperating

with alarm system to catch events’ images. Refer to alarm pin definition below to

connect alarm devices to the IS-IP290 if needed.

Alarm

Definition

Please refer to User’s Manual for Alarm Pin Definition to connect the alarm

devices.

Alarm

Switch

The Administrator can enable or disable the alarm function.

Alarm

Type

Select an alarm type, <Normal close> or <Normal open>, that corresponds with

the alarm application.

Alarm

Output

Define alarm output signal <high> or <low> as the normal alarm output status

according to the current alarm application.

Triggered

Action (Multi-option)

The Administrator can specify alarm actions that will take when the alarm is

triggered. All options are listed as follows:

 Enable Alarm Output

Select the item to enable alarm relay output.

 IR Cut Filter

Select the item and the camera’s IR cut filter (ICR) will be removed (on)

or blocked (off) when alarm input is triggered.

Note: The IR Function (Refer to IR Function) could not be set as

<Auto> mode if this triggered action is enabled.

 Send Message by FTP/E-Mail

The Administrator can select whether to send an alarm message by FTP

and/or E-Mail when an alarm is triggered.