User`s manual

19
2.2.3.3 SNMP
The SNMP (Simple Network Management Protocol) setting can be found under
this path: System> Network> SNMP.
With Simple Network Management Protocol (SNMP) support, the IS-IP290
can be monitored and managed remotely by the network management system.
SNMP v1/ v2
 Enable SNMP v1/ v2
Select the version of SNMP to use by checking the box.
 Read Community
Specify the community name that has read-only access to all supported
SNMP objects. The default value is “public”.
 Write Community
Specify the community name that has read/write access to all supported
SNMP objects (except read-only objects). The default value is “write”.
Traps for SNMP v1/ v2
Traps are used by the IS-IP290 to send massages to a management system
for important events or status changes.
 Enable Traps
Check the box to activate trap reporting.
 Trap address
Enter the IP address of the management server.
 Trap community
Enter the community to use when sending a trap message to the
management system.
Trap Option
 Warm Start
A Warm Start SNMP trap signifies that the SNMP device, i.e. IS-IP290,
performs software reload.
Click on <Save> button when complete.