Product specifications

Part No. 960-000159R_Rev. 1 © 2013, JCM Global, Corporation
22
Sentry® 2.0 Intelligent Bezel Software Guide April, 2013
R EMOTE A CCESS D EVICE M AINTENANCE
The Remote Access Device (RAD) uses
a Battery to operate its RF output signal,
which occasionally requires changing.
To change the Battery:
1. Turn the RAD Unit upside-down, and
locate the Battery Door Latch on the
back end of the Unit (Figure 14 a).
2. Press in on the Latch, as indicated on
the RAD Unit Case (Figure 15 a),
while simultaneously pulling the Bat-
tery Door outward away from the Unit
Body (Figure 15 b).
3. Pull the Battery Door out completely,
to fully expose the Coin Cell Battery
(Figure 16 a).
4. Replace the Battery with a Type
CR2025 Cell Coin Type ONLY!
5. After replacing the Battery, slide the
Battery Door into the RAD Unit until
it clicks into place (Figure 16 b).
If the Remote Access Device fails to
function, verify the following:
• Remote Access Device access has been “Enabled” on the Sentry 2.0 Bezel using the
Sentry Configuration Utility.
• No obstructions or other items are blocking the Sentry 2.0 Bezel’s Front Panel Receiver
Lens.
• The Protective Plastic Battery shipping “Keeper Strip” has been removed from the
Remote Access Device Unit.
• The Battery is inserted properly (Positive + Side Up), when referenced from the rear of
the RAD Unit.
In most cases, Remote Access Device failures can be attributed to one of the
above conditions, or to an exhausted Battery. Replace the Battery as often as
needed.
Figure 14 RAD Battery Door Latch
a
Figure 15 Opening Battery Door
a
b
Figure 16 Replacing RAD Battery
a
b
NOTE: Make sure the Positive (+)
side of the Battery is facing up in
relation to the backside of the RAD
Unit Case.
NOTE: When Battery power is nearly exhausted, place the Remote
Access Device closer to the Sentry 2.0 Display Lens to ensure
proper functionality and activate Attendant Mode. Replace the
Battery in the RAD as soon as possible!
Part No. 960-000159R_Rev. 1 © 2013, JCM Global, Corporation
7
April, 2013 Software Guide Sentry® 2.0 Intelligent Bezel
ATTRACT MODE
D ELAY C ONFIGURATION
When the Banknote Validator is disabled, the Sentry 2.0 LCD Display dims, to
avoid Player attraction. The Delay slider bar on the “Configuration” tab adjusts
the Delay Value between a “Short” and a “Long” duration. The Delay Value (in
Seconds) is displayed above the slider bar (Figure 4 a).
Once the Banknote Validator is enabled, the Sentry 2.0 LCD Display is restored to
full brightness following expiration of the Delay Value (in seconds).
NOTE: In Attract Mode, the LCD Display appears in full brightness
when the Banknote Validator is enabled. The Delay period (in seconds)
begins when the Validator is enabled, continues as the screen
brightens, and expires when reaching final Attract Mode brightness.
Figure 4 Attract Mode Adjustment Settings and Key Fob Activation Screen
a
b
c