Operating instructions

40 Cone-Fire / Ramp-Hold
Sentry Cone-Fire Shorthand Programming
After you press the key(s) in the left column, the message to the right will appear. Press from . If the key does not
respond, your controller does not have Cone-Fire. (See also page 11.)
KEYS TO PRESS DISPLAY COMMENTS
Apply power to kiln Press Enter if IdLE doesn’t appear.
1 Enter the cone number.
Cone # (i.e. 05)
ENTER Enter the firing speed.
1(Fast), 2 (Med.), or 3 (Slow) The firing speed appears.
ENTER Enter Pre-heat time.
Pre-Heat time (0 if none) Pre-heat time appears.
ENTER Enter hold time.
Hold time (0 if none) Hold time appears.
ENTER Enter slow cooling rate.
Slow cooling rate (0 if none) Shows degrees per hour.
ENTER Kiln is ready to fire.
ENTER Kiln is now firing. Press 6 for
Program Review.
The Kiln is now firing to the cone you selected.
Appendix G: