Product manual

MultiPoint Level Control System
18
E 2001 Nordson Corporation
All rights reserved
321 351A
Issued 7/01
69–LVL–EH–IS–01
5. Route a 1-phase, 120 VAC input power supply line through the strain
relief and connect it to terminals XT1-1 and XT1-2 inside the level
control cabinet.
6. Connect the input power supply line ground wire to XT1-3 inside the
level control cabinet.
7. Refer to feed unit manual and applicator manuals for specific setups.
The RIA 450 Level Controller is pre-programmed prior to shipping. Check
the program settings to confirm the correct settings. If the settings are not
correct, reset per the Pre-set Programming Values listed in Figure 6.
Fig. 6 Preset Programming Values
Wiring Instructions (contd)
4. System Setup
Verifying Program Values