Product manual

MultiPoint Level Control System

E 2001 Nordson Corporation

321 351A

Issued 7/01

69–LVL–EH–IS–01

1. Mount the level control cabinet in a location as far away as possible

from vibration, corrosive atmosphere and potential mechanical

damage.

NOTE: in order to prevent signal drop-off, it is recommended that the

level control cabinet be located as close as possible to the filling cabinet.

(This instruction applies to the distance between the feed unit and the

level control box).

1. Install two strain reliefs, one at each of the two holes in the bottom of

the level control cabinet. Use the strain relief on the right for steps 2,

3, and 4. Use the strain relief on the left for step 5.

2. Using the wiring diagram in the Schematics section of this manual as

a guide, connect a set of customer-supplied 22 AWG or 24 AWG wire

leads inside the level control MultiCap Probe to XT1, inside the level

control cabinet.

Connect MultiCap Probe Wire To Control Box Panel

#1 XT1 – #8

#2 XT1 – #9

#3 XT1 –#10

NOTE: The level control cabinet can be located up to 1,000 m from the

MultiCap Probe assembly when 18 AWG is used. (This instruction

applies to the distance between the MultiCap Probe and the Level

Control Box).

3. Using the wiring diagram in the Schematics section of this manual as

a guide, connect the pair of customer-supplied 22 AWG or 24 AWG

wire leads from terminals XT1-4 and XT1-5, in the Control Box, to the

feed unit. See feed unit applicator manual for the wiring position.

4. Using the wiring diagram in the Schematics section of this manual as

a guide, connect the 120 VAC gun solenoid valve leads to XT1-6 and

XT1-7, inside the level control cabinet. See feed unit manual for hose

and gun connections.

WARNING: This equipment contains electrical potentials that

are dangerous and could be fatal. Disconnect and lock out input

electrical power before connecting the input power supply line

to this unit. Failure to observe and follow this warning could

cause death.

Mounting the Level Control

Cabinet

Wiring Instructions