Product manual

MultiPoint Level Control System
16
E 2001 Nordson Corporation
All rights reserved
321 351A
Issued 7/01
69–LVL–EH–IS–01
This section contains the installation procedures necessary to install the
MultiPoint Level Control System for various applicators.
Inventory and inspect the MultiPoint Level Control System components.
The gun, solenoid, and filter/regulator are ordered and shipped
separately.
WARNING: Warning on RIA 450 Level Controller: Disconnect
power before opening cabinet ground equipment. Failure to
follow these instructions may result in death.
1. Remove the hinged lid and hopper enclosure from the applicator.
S Refer to the applicator manual for detailed instructions and
parts list.
2. Assemble the following components to the hopper enclosure using
the fasteners supplied with this kit.
S Mounting plate
S Mounting spacer
S Hopper cover
S Loading kit
3. Install the hydraulic connectors to the hopper enclosure assembly.
NOTE: The gun-to-cover connection is different than a hose-to-cover
connection. These differences are shown in Figures 12 and 13.
NOTE: Reference the H20 Gun Manual for connection instructions.
If a Gun is not required:
1. Connect feed unit hose to the male connector
2. Connect male connector to the tank/hopper cover
1. Connect the H20 gun to the adapter
2. Connect the adapter to the bushing
3. Connect the bushing to the tank cover
3. Installation
Connecting the Feeding Unit to
the H20 Gun
Connecting the Feeding Unit
Without a Gun
Connecting the H20 Gun to the
Lid Kit/Applicator Unit