Product manual

MultiPoint Level Control System
8
E 2001 Nordson Corporation
All rights reserved
321 351A
Issued 7/01
69–LVL–EH–IS–01
General Safety Warnings and Cautions (contd)
WARNING: System pressurized! Relieve system hydraulic
pressure before breaking any hydraulic connection or seal.
Failure to relieve the system hydraulic pressure can result in the
uncontrolled release of hot melt that can cause personal injury.
WARNING: Molten Material! Wear eye or face protection,
clothing that protects exposed skin, and heat-protective gloves
when servicing equipment that contains molten hot melt. Even
when solidified, hot melt can still cause burns. Failure to wear
appropriate personal protective equipment can result in
personal injury.
WARNING: Equipment starts automatically! Remote triggering
devices are used to control automatic hot melt guns. Before
working on or near an operating gun, disable the gun’s
triggering device and remove the air supply to the gun’s
solenoid valve(s). Failure to disable the gun’s triggering device
and remove the supply of air to the solenoid valve(s) can result
in personal injury.
WARNING: Risk of electrocution! Even when switched off and
electrically isolated at the disconnect switch or circuit breaker,
the equipment may still be connected to energized auxiliary
devices. De-energize and electrically isolate all auxiliary
devices before servicing the equipment. Failure to properly
isolate electrical power to auxiliary equipment before servicing
the equipment can result in personal injury, including death.
WARNING: Risk of fire or explosion! Nordson cold adhesive
equipment is not rated for use in explosive environments and
should not be used with solvent-based adhesives that can
create an explosive atmosphere when processed. Refer to the
MSDS for the adhesive to determine its processing
characteristics and limitations. The use of incompatible
solvent-based adhesives or the improper processing of
solvent-based adhesives can result in personal injury, including
death.