Specifications

GENERAL INFORMATION
S10 9007293 (2--10)
2
SAFETY PRECAUTIONS
The following symbols are used throughout this
manual as indicated in their description:
W ARNING: To warn of hazards or
unsafe practices that could result in
severe personal injury or death.
FOR SAFETY: To identify actions that
must be followed for safe operation of
equipment.
The following information signals potentially
dangerous conditions to the operator or
equipment. Read this manual carefully. Know
when these conditions can exist. Locate all
safety devices on the machine. Then, take
necessary steps to train machine operating
personnel. Report machine damage or faulty
operation immediately. Do not use the machine
if it is not in proper operating condition.
W ARNING: Batteries emit hydrogen
gas. Explosion or fire can result. Keep
sparks and open flame away. Keep
covers open when charging.
W ARNING: Disconnect battery cables
and charger plug before servicing
machine. Do not charge batteries with
damaged power supply cord. Do not
modify plug.
If the charger supply cord is damaged or
broken, it must be replaced by the
manufacturer or its service agent or a
similarly qualified person in order to avoid a
hazard.
W ARNING: Heavy hopper. Do not
remove without help. Can cause back
strain.
This machine is not equipped with
explosion proof motors. The electric motors
will spark upon start up and during
operation which could cause a flash fire or
explosion if machine is used in an area
where flammable vapors/liquids or
combustible dusts are present.
FOR SAFETY:
1. Do Not Operate Machine:
-- Unless Trained And Authorized.
-- Unless Operation Manual Is Read
And Understood.
-- In Flammable Or Explosive Areas
Unless Designed For Use In Those
Areas.
-- Do Not Pick Up Flammable Or Toxic
Material, Burning Or Smoking
Debris, Or Hazardous Dust
2. Before Starting Machine:
-- Make Sure All Safety Devices Are In
Place And Operate Properly.
3. When Using Machine:
-- Go Slow On Grades And Slippery
Surfaces.
-- Use Care When Backing Machine.
-- Do Not Operate On Inclines That
Exceed 8.75% (5º) With A Full
Hopper, Never Operate On Inclines
That Exceed 12.2% (7º)
4. Before Leaving Or Servicing Machine:
-- Stop On Level Surface.
-- Set Parking Brake.
-- Turn Off Machine And Remove Key.
5. When Servicing Machine:
-- AvoidMovingParts.DoNotWear
Loose Jackets, Shirts, Or Sleeves
When Working On Machine.
-- Use Hoist Or Jack Of Adequate
Capacity To Lift Machine.
-- Wear Eye And Ear Protection When
Using Pressurized Air Or W ater.
-- Disconnect Battery Connections
Before Working On Machine.
-- Avoid Contact With Battery Acid.
-- Use TENNANT Supplied Or
Equivalent Replacement Parts.
6. When loading/unloading machine
onto/off truck or trailer.
-- Turn off machine.
-- Use truck or trailer that will support
the weight of the machine.
-- Block machine tires.
-- Tie machine down to truck or trailer.
Home
Find...
Go To..