Specifications

MAINTENANCE
S10 9007293 (2--10)
22
DUST FILTER
The dust filter is located inside the dust filter
compartment. The filter shaker will shake the
filter for 20 seconds when the machine is
powered off. Inspect and clean or replace the
dust filter after every 100 hours of operation.
NOTE: The filter shaker override switch must be
in the “on” position to automatically shake the
dust filter when the machine is turned off. The
filter shaker override switch should be in the
“on” position for most operations.
Use one of the following methods to clean the
dust filter:
D TAP -- Tap the filter gently on a flat surface
with the dirty side down. Do not damage
the edges of the filter element or the filter
will not seat properly in the filter frame.
D AIR -- Blow compressed air, 240 kPa
(35 psi) maximum, through the dust filter
opposite the direction of the arrows on the
side of the filter . This may be done with
the filter in the machine. Always wear eye
protection when using compressed air.
FOR SAFETY: When servicing machine,
wear eye and ear protection when using
pressurized air or water.
REMOVING THE DUST FILTER
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, set parking
brake, and turn off machine.
1. Loosen the six front filter cover screws and
remove the front filter cover.
2. Remove the filter hold-down plate.
Remove the dust filter.
3. Inspect and clean or replace the dust filter.
INST ALLING THE DUST FILTER
1. Position the dust filter in the filter frame
with the arrows on the side of the filter
pointing away from the machine.
2. Position the filter hold-down plate on the
filter.
3. Secure the front filter cover on the filter
frame with the six front filter cover screws.
Home
Find...
Go To..