Installation Guide

IMPORTANT CAUTIONS:

During testing and operation, keep hands and ngers clear of moving parts of lock, gate and gate

opener to avoid injury. Always wear protective eye wear during installation.

PARTS INVENTORY

GENERAL TOOL REQUIREMENTS

Tools required for most installations:

• Wrench – 9/16 inch • Socket 3/8 inch

• Drill • Drill bits 1/8 and 3/8 inch

• Pliers • Level

• Hack saw • Tape measure

Welding is the recommended method of securing the lock mounting plate and the strike bracket to the

gate and hinge post. The Lock Housing should NEVER be welded. Internal parts can be damaged by

excessive heat. Bolt on brackets are provided and are acceptable but may require frequent service to

keep tight. They must be very securely attached (i.e. carriage bolts with lock nuts and washers).

Lock Housing

Part # 070660

Lock Mounting Bracket

Part # 070670

Strike Bracket

Part # 070680

Strike Pin with Clip

Part # 610516

3/8” X 2” Bolts

Part # 610508

4 per

3/8 x 4” Carriage Bolts

Part # 610506

2 per

3/8 x 6” Carriage Bolts

Part # 610504

2 per

3/8” Lock Nuts

Part # 610502

8 per

1/8” Allen Wrench

Part # 610500

7/8” Rubber Plugs

Part # 610501

2 per

Wire Nut

Part # 620018

2 per