User manual

StoreSafe Pro II
User Manual
40
Figure 24. The event record rate menu
1. Rotate the Jog to navigate, and the Shuttle to change the values.
2. To save changes and exit the menu: Select [OK], and then press the Enter button.
3. To exit the menu without making changes: Press the Menu button, or select [CANCEL], then press
the Enter button.
Main Menu / Record / Activity Record Rate
The unit will record at the Activity Record Rate when the camera is in normal Timelapse Record Mode and
activity is detected in the camera scene. Activity should not be linked to Event, in which case the Event Record
Rate will be used.
Record rates are measured in both Pictures Per Second (pps) and Seconds Per Picture (spp).
The maximum record rate per camera is inversely proportional to the number of cameras connected to the unit.
The fewer cameras connected, the higher the maximum record rate for each camera, and vice versa. The
maximum record rate for multiple cameras is 24pps (NTSC). The maximum record rate for a single camera is
60pps (NTSC).
The bottom right corner of the menu contains a record duration calculator. The top line indicates the estimated
recording time of the cameras in Activity record mode only. The bottom line indicates the estimated recording
time, taking into consideration the amount of time the unit will spend in Time-lapse, Activity, Event, and/or
Alarm record mode.
Event Record Rate
Camera 1 :
Camera 2 : 0.29 pps 3.5 spp
Camera 3 : 0.34 pps 2.9 spp
Camera 4 : 0.57 pps 1.8 spp
:
:
:
Camera 9 : 0.40 pps 2.5 spp
Camera 10 : 0.40 pps 2.5 spp
0.40 pps 2.5 spp
[CANCEL] [OK]
125 days 8 h (EVENT)
10 days 7 h (Total)
% Time: 4%
Estimate of the % of time each
camera will typically spend in
Event mode. For example if you
expect to have about 20 total
events each day, each lasting 3
minutes on average, then the %
of the time will be
(1 hour/24 hours)
4%.
% Time: 4%