User manual

StoreSafe Pro II

User Manual

detailed information about sequencing, see Sequencing on page 21. This feature is not available on the 4-

channel units.

Full Screen Display

Select any camera for Full Screen display by pressing the Number button of the desired camera. Pressing the

Camera number button again displays the Status Display Box. Pressing the same button a third time displays

any associated ATM or cash register ASCII text.

Sequenced Full Screen Display

While in a Full Screen display, press the Sequence button to begin full screen sequencing. The sequence list is

programmable. For detailed information about programming the sequence list see Sequencing on page 21.

Zooming

To activate the 2x digital zoom, select the full screen display of the camera you wish to zoom, then press the

Zoom button. Zooming will be indicated by the LED located directly above the Zoom button. Zooming is also

indicated as ZOOM on the monitor. Zooming works with frozen and non-frozen images. Zoomed images can

also be frozen.

While Zoomed, use the Jog/Shuttle to Pan and Tilt across the image. Please note, the camera does not move

during digital Pan/Tilt.

Press the Zoom button again, or another camera button to cancel the Zoom operations.

Note: If the Zoom button is pressed while in a multiscreen display, the camera from the last active cameo is selected for full

screen display. Press the Zoom button again to activate the Zoom operation.

The Print Image Button

Pressing the Print Image button will print the currently displayed image. If a 4-way multiscreen is the display

mode, StoreSafe Pro II will switch to a single image display of the last selected fullscreen camera, freeze the

image, and send to the default printer.

Printer Setup

The following equipment and conditions are required for the operation of the Print Image button.

Equipment

HP DeskJet 3820

Hawking Print Server PN7127P

Conditions

The Printer and Print Server must be connected to the same local network as StoreSafe Pro II.

StoreSafe Pro II must know the Print Servers IP address. The IP address can be input under Main Menu /

Communications / Ethernet Settings (See Main Menu / Communications / Ethernet Settings on page 67).