User manual

StoreSafe Pro II

User Manual

Note: The unit must be in Full Screen Display mode before starting to create the sequence list. This initial camera is not part

the sequence list.

To begin recording the Autolist™ sequence: Press the Alarm button and Sequence button simultaneously.

Autolist Program mode is indicated as PGM on-screen. Recording starts when the first camera number is

pressed. Press the camera numbers in the order you wish them to appear on-screen. The amount of time

between button presses determines the Dwell Time. During sequence list programming, pressing any button

other than a Number button or the Sequence button voids the sequence list.

To end the recording: Press the Sequence button. The amount of time between pressing the last Number

button and the Sequence button determines the dwell time for the final camera in the sequence list.

Returning To The Default Sequence List

The default sequence list is all cameras in numeric order with a three second dwell time.

To return the unit to the default sequence list, go to the Main Menu / Factory Settings menu.

Sequencing In Cameos

While viewing a multiscreen display, additional cameras (cameras not shown in the multiscreen display) can be

sequenced in the lower right hand cameo by pressing the Sequence button. The sequence list is not

programmable. Press the Sequence button again to cancel sequencing.

On-screen Indicators

There are five types of on-screen indicators.

• Camera Titles: Displays the camera number and the camera title.

• Status Indicators: Displays Time, Date, and Hard Disk record time left.

• Conditional Indicators: Displays indicators for Freeze, Zoom, Alarm, Motion Detection, Video loss,

Autolist™ Program mode, Macro Record and Macro Playback mode.

• Status Display Box: Displays Archive Device, Network status and Image Quality Setting (Playback

mode only).

• Text Display Box: Displays ATM/POS Text data.

Camera Titles

Camera Titles are displayed on either the upper or lower corner of the left hand side of the screen. The camera

title can be changed in the menu system (see Main Menu / Camera Setup / Camera Titles on page 59). The user

can change display position and color. See below.

CAUTION

Initiating the Factory Setting menu command returns all settings (except the time, date, email addresses,

and email IP address) back to the original factory defaults. This will cause the loss of any custom settings.