User manual

StoreSafe Pro II

User Manual

Full Screen Display

Select any camera for Full Screen display by pressing the Number button of the desired camera. Pressing the

Camera number button again displays the Status Display Box. Pressing the same button a third time displays

any associated ATM or cash register ASCII text.

Sequenced Full Screen Display

While in a Full Screen display, press the Sequence button to begin full screen sequencing.

Zooming

To activate the 2x digital zoom, select the full screen display of the camera you wish to zoom, then press the

Zoom button. Zooming will be indicated by the LED located directly above the Zoom button. Zooming is also

indicated as ZOOM on the monitor. Zooming works with frozen and non-frozen images. Zoomed images can

also be frozen.

While Zoomed, use the Jog/Shuttle to Pan and Tilt across the image. Please note, the camera does not move

during digital Pan/Tilt.

Press the Zoom button again, or another camera button to cancel the Zoom operations.

Note: If the Zoom button is pressed while in a multiscreen display, the camera from the last active cameo is selected for full

screen display. Press the Zoom button again to activate the Zoom operation.

Searching Recorded Data

StoreSafe Pro II has a powerful search interface feature that allows the user to search for data on the internal

hard disk. The user may search the data for previous recording sessions, text insertion, and alarm conditions.

Because the search interface is so dynamic, the search interface is covered in detail in a separate section of this

manual. See Searching on page 77.

Recording

To begin recording, press the Record button. Recording will be indicated by the LED located directly above the

Record button. The unit always starts recording at the end of previously recorded data. The unit will continue

recording until the record button is pressed again, unless Record Lock is ON.

StoreSafe Pro II also remembers its current record mode in the event of power loss. If the unit was recording

during a power loss, then when power is restored the unit will put itself back in that mode.

Monitor Displays During Recording

Multiscreen Live and Playback displays on Monitor A and Monitor B are not affected by recording operations.