Operating instructions

C2676M-A (8/09) 9
REMOVING THE MOUNTING BASKET
1. If HDD drives are already installed, disconnect the SATA HDD power connector and data cable (refer
to Figure 5):
a. Grasp the top and bottom of the SATA power connector and carefully and simultaneously pull
straight back on the connector.
b. Grasp each side of the SATA data connector and carefully and simultaneously pull straight
back on the connector.
Figure 5. Disconnecting the Data and Power Cables
2. Remove the HDD mounting basket (refer to Figure 6):
a. Using a Phillips screwdriver, unscrew the four screws that attach the mounting basket to the
chassis.
b. Gently lift the basket up and out with the drives attached. Be careful not to force the basket
free or to disturb other components inside the unit.
Figure 6. Lifting the Mounting Basket