Operating instructions

C2676M-A (8/09) 3
Important Safety Instructions
Be sure to read familiarize manual and all safety instructions and before proceeding with the HDD
installation.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
7. Only use attachments/accessories specified by the manufacturer.
8. Installation should be done only by qualified personnel and conform to all local codes.
9. CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce
the risk of electric shock do not perform any servicing other that contained in the operating
instructions unless you are qualified to do so.
10. Only use replacement parts recommended by Pelco.
11. The unit must be properly shut down and turned off to install the system and video data drive.
WARNING: It is critical that the DX4500/DX4600 be unplugged for your safety. You must remove the
power cord because current continues to flow through the DX4500/DX4600 even when the unit is off.
First, unplug the power cord from the wall socket, then unplug it from the rear of the DVR.
12. Make sure you protect the unit and its components from electrostatic discharge (ESD).
The product and/or manual may bear the following marks:
This symbol indicates that dangerous voltage
constituting a risk of electric shock is present within
this unit.
This symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
WARNING: This product is sensitive to Electrostatic Discharge (ESD). To avoid ESD damage to this
product, use ESD safe practices during installation. Before touching, adjusting or handling this product,
correctly attach an ESD wrist strap to your wrist and appropriately discharge your body and tools. For
more information about ESD control and safe handling practices of electronics, please refer to ANSI/
ESD S20.20-1999 or contact the Electrostatic Discharge Association (www.esda.org).
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
The materials used in the manufacture of this document and its components are compliant to the requirements of
Directive 2002/95/EC.
This equipment contains electrical or electronic components that must be recycled properly to comply with
Directive 2002/96/EC of the European Union regarding the disposal of waste electrical and electronic equipment
(WEEE). Contact your local dealer for procedures for recycling this equipment.