Operating instructions

12 C2676M-A (8/09)
Reassembling the Unit
1. Replace the chassis cover using the screws you removed (refer to Figure 11).
Figure 11. Replacing the Chassis Cover
2. Attach the silver product label for your upgrade kit to the inside of your unit front door.
NOTE: In the event that your unit or its components require service, specific labels must be present
and appropriately affixed to the unit’s door. Pelco product support personnel use these labels to
identify the exact components installed in your system. A separate product label is required for each
upgrade component installed on the DX4500/DX4600.
3. Reinstall the unit in the rack enclosure if necessary. Then reconnect all of the cables and peripheral
equipment you removed earlier.
To complete the HDD installation, refer to Formatting on page 13.