Operating instructions

C2676M-A (8/09) 11
REINSTALLING THE MOUNTING BASKET
1. Reinstall the HDD mounting basket (refer to Figure 9):
a. Gently lower the basket into place. Be careful not to force the basket into place or to disturb
other components inside the unit.
b. Using a Phillips screwdriver, fasten the four screws that secure the drive basket to the
chassis.
Figure 9. Replacing the Mounting Basket
2. Reconnect the SATA data and power cables for each HDD (refer to Figure 10):
a. Grasp each side of the SATA data connector and carefully and evenly push the connector on to
the drive data connector. Ensure that the plug is pushed all the way on to the drive data
connector.
b. Grasp the top and bottom of SATA power connector and carefully and evenly push the
connector on to the drive power connector. Ensure that the connector is pushed all the way on
to the power connector.
NOTE: Make sure you connect the correct power and data connectors to the correct drives.
Figure 10. Reconnecting the Data and Power Cables