Use and Care Manual

Sentry Safety Pool Fence 13100 State Road 54, Odessa, FL 33556 1-877-349-3362
Installation: Modifying a section
1. D
rill your last hole where you need it
.
2. M
easure from the last hole to second last hole; center hole to center hole
.
3. R
emove the backing by unscrewing the screws on the back of the pole using a Roberts
on #2
s
crewdriver
.
4. M
easure on the mesh the same measurement you measured on the ground Add a 3/4” the
n
c
ut the lining; then measure 1.5” or more of mesh and cut
.
5.
Lay the pole centered on the original measurement. The extra lining should go past the pole
.
6. F
old the extra mesh and re-attach the backing. Cut off any extra mesh to clean up the look of
the fence
.