Use and Care Manual

Sentry Safety Pool Fence 13100 State Road 54, Odessa, FL 33556 1-877-349-3362
Installation: Insert Sleeves and Erect Fence
Every hole should have a plastic sleeve inserted into it.
Important: The sleeve should be tight in the hole however you should be able to push the
sleeve about 80 percent of the way into the hole pushing down with the heel of your palm and
tap with a blunt object like a mallet the remaining way in.
If you cannot, do not force the sleeve. Pull it back out and using your drill run the bit up and
down the hole putting slight pressure on the side walls of the hole. Then try reinserting the
sleeve.
If you force the sleeve the pole will also be tight and make it more difficult to be removable.
Next stand your fence upright in the holes with sleeves in them. When you are first installing
the fence expect there to be tension to reach from base of pole to base of pole. Tension at the
top of the poles however is not achieved until after the sections of fence are fully attached to
one another by hook and eyes.
General rule is you should be able to
push by hand (still with firm force)
the sleeve about 80% into the hole.