Use and Care Manual

Sentry Safety Pool Fence 13100 State Road 54, Odessa, FL 33556 1-877-349-3362
Installation: Drilling at angles
When installing the pool fence any poles that are not on a straight run should be angled at either
2.5 degrees or 5 degrees. Also an angle would be used at the end of fence sections. The top of
the pole should be leaning away from the turn.
0 Degrees (No Angle)
On straight runs of pool fence the hole
should be drilled at 0 degree. Without
any angling at all.
2.5 Degrees
If the change of direction of fence is less than
90 degrees or if you are at the end of one
fence section and starting a new fence section
the hole should be drilled at 2.5 degrees.
On a turn the drilling should lean AWAY
from the turn.
At the end of a section the drilling should lean
the two poles toward each other.
5 Degrees
If the change of direction of fence is 90
degrees the hole should be drilled at 5
degrees.