Use and Care Manual

Sentry Safety Pool Fence 13100 State Road 54, Odessa, FL 33556 1-877-349-3362
Installation: Marking Your Holes
Your fence comes with a hole template. Mark your entryway first with a pencil. The entryway
is a point where you want two sections to meet so you can unhook them from one another and
enter your fenced area.
If you purchased a hinged gate: proceed to the measurements section of this manual for
the gate and mark the gate holes first, then return to this section of the manual and pro-
ceed with marking the fence holes.
After marking the entryway, continue using the template to mark your fence both directions
from your entry way. You can change
directions at every pole. After every 5th pole you will have two poles next to one another
where you are starting a new section.
IMPORTANT: Before marking holes check the distance from center hole to center hole
on the template using a tape measure to make sure you are choosing the correct holes to
use for your fence. Also check a section in the holes after drilling your first two of holes:
• 36”: 4’ tall safety fence - pole
to pole
• 30”: 5’ tall safety fence - pole
to pole
• 2.5”: Spacing between fence
sections where two poles will
be next to each other
.