Material and Safety Data

Safety Data Sheet
Product X100 Page 3 of 7
Supersedes: Version 3, dated June 2013 Version: 4 Date Prepared: June 2015
Handling Avoid contact with skin and eyes. Do not ingest or inhale
vapors or spray.
Storage Keep in original containers. Keep container tightly closed.
Store in cool, well ventilated area. Protect from freezing
and from high temperatures.
Recommended engineering controls Ensure good ventilation. Arrange for eye wash possibility.
Control parameters: Molybdenum compounds (as Mo) soluble
OSHA PEL - 5 mg/m
3
8 hr TWA
ACGIH TLV - 5 mg/m
3
8 hr TWA
Monitoring procedures Not required.
Personal protection
Always check applicability with your supplier of protective equipment.
- Respiratory protection In case of insufficient ventilation, wear full face or half face
mask fitted with filter suitable for liquid particulates.
- Skin protection Laboratory coat or overalls
if splashing or repeated contact
with product is likely.
- Eye protection Chemical goggles or full face visor.
- Hand protection Plastic, impervious gloves for protection against
unintentional short-term contact. However, since glove
performance is governed by many variables, it is strongly
recommend that specialist advice on the selection and use of
protective gloves is sought.
Appearance Colourless to yellow liquid
Odor Mild
Odor threshold No information available
pH (concentrated product) 6.4
Melting point (ºC) Approx 0 [32°F]
Boiling point/range (ºC) Approx 100 [212°F]
Flash point Not flammable
Evaporation rate (ether=1) No information available
Flammability (solid/gas) Not relevant
Vapor pressure No information available
Vapor density No information available
7. HANDLING AND STORAGE
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
9. PHYSICAL AND CHEMICAL PROPERTIES