SDS

Sentinel 747 Plus Mastic Remover
(VOC Compliant) Safety Data Sheet
Prepared according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations
11/02/2015
Sentinel 747 Plus Mastic Remover (VOC
Compliant)
3/7
Emergency procedures
:
Evacuate unnecessary personnel.
6.1.2. For emergency responders
Protective equipment
:
Wear suitable protective clothing, gloves and eye or face protection. Approved supplied-air
respirator, in case of emergency.
6.2. Environmental precautions
Prevent entry to sewers and public waters. Notify authorities if liquid enters sewers or public waters. Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
For containment
:
Contain any spills with dikes or absorbents to prevent migration and entry into sewers or
streams. Foam may be used to suppress vapors.
Methods for cleaning up
:
Soak up spills with inert solids, such as clay or diatomaceous earth as soon as possible. Place in
a suitable container for disposal in accordance with the waste regulations (see Section 13).
6.4. Reference to other sections
No additional information available
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Precautions for safe handling
:
Do not handle until all safety precautions have been read and understood. Wash hands and
other exposed areas with mild soap and water before eating, drinking or smoking and when
leaving work. Provide good ventilation in process area to prevent formation of vapor. Do not
breathe mists. Keep away from sources of ignition - No smoking.
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions
:
Keep only in the original container in a cool, well ventilated place away from : Heat sources.
Keep container closed when not in use.
7.3. Specific end use(s)
No additional information available
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Petroleum distillates, hydrotreated light (64742-47-8)
Remark (ACGIH)
OELs not established
Remark (US OSHA)
OELs not established
2-(2-butoxyethoxy)ethanol (112-34-5)
Remark (ACGIH)
TWA - 10 ppm
Remark (US OSHA)
OELs not established
Surfactant (Proprietary*)
Remark (ACGIH)
OELs not established
Remark (US OSHA)
OELs not established
8.2. Exposure controls
Appropriate engineering controls
:
Ensure adequate ventilation, especially in confined areas.
Personal protective equipment
:
Gloves. Protective clothing. Protective goggles. Respiratory protection of the dependent type.
Hand protection
:
Use gloves chemically resistant to this material when prolonged or repeated contact could occur.
Gloves should be classified under Standard EN 374 or ASTM F1296. Suggested glove materials
are: Natural rubber (“latex”), Neoprene, Nitrile/butadiene rubber, Polyethylene, Ethyl vinyl
alcohol laminate, PVC or vinyl.
Eye protection
:
Eye protection, including both chemical splash goggles and face shield, must be worn when
possibility exists for eye contact due to spraying liquid or airborne particles.