User's Manual

Industrial PDA
equipment for charging.
Insert the charger into the power socket with
100~240V, 50/60Hz. When it is charging, the battery power
icon on the screen will shine; after charging finished, the
battery power icon on the screen will stop shining.
After charging finished, pull the charger out of the
equipment and then pull the charger out of the power
socket.
Charging time
If the AC voltage is very low, you should charge the
battery for a long time. It will lengthen the charging time in
the using process of the equipment.
The charging time is about 6 hours. More accurate
time will depend on the battery condition. The environment
temperature of normally charging should be 0 ~40 .
Charging under below 0 or above 40 , the battery
performance will descend and the battery life will shorten.
When charging under too high or too low temperature for a
long time, it will cause damage to the battery. It will
lengthen the charging time to use nonstandard charger. It
will also lengthen the charging time to operate the tester
when charging.
Note:
■ You should fully charge the tester before the first usage;
please disconnect the charger in time after charging
finished because the long-time charging will damage the
battery performance.