Installation Guide

Probe Settings Menu
Settings
– Allows the user to customise the probe settings to their own preferences.
Clear Data
– Clears all data records stored on the probe.
Force Download
– Forces download of all data records stored on the probe regardless of whether or not they have already been
downloaded to the mobile device.
About
– Provides details regarding the version of code installed on the probe – as well as any error codes if errors have occurred. (These
need to be reported to Technical Support
.)
Settings Menu
Details of the Probe Menu settings are shown on the right.

Device Name – Allows the probe to be named –
this will also be the name of the
graph in IrriMAX live (or IrriMAX desktop).

Sample Interval set the rate at which the probe samples. A pre-selected list is
provided from 1min to 12 hours.

Select Owner ID to set –
allows the probe to be assigned to nay of the owners in
the owners ID list.

The Serial Number is set by Sentek during manufacture – it provides the probe
with a unique
identification. (This number is required should the probe need to
be unlocked.)

Transmit Signal Strength setting allows a +4dBm gain/increase to the probes
transmission level but doing so will reduce the battery life.

Enable Firmware Update Notification – when enabled will prompt the user to
upgrade whenever the app is newer than the probe. (When disabled it will not.)

Enable Advanced User – changes the options available in the probe settings
menu – allowing sensors to be configured in the “Sensor Test” page (ABCD
values and probe normalisation)

Date out of sync Warning allows the user to set how far out the time is
permitted to drift before a warning is displayed.

Add new owner ID – allows the user to enter new owner ID’s to the mobile
device’s owner IDs list.

Owner IDs List– Displays a list of all owner IDs that have been added to the
mobile devices allowing them to be selected as included/excluded from the
scanned/device lists.
Scroll Down