User's Manual

Rev S-00001-20051010-1 Page 5 of 15
3 Installation
NOTE: Sensys Networks is exempt from all responsibility of damage and injury caused by
the installation or improper installation of either of the VSN240-F or VSN240-S sensors.
Sensys Networks can recommend a “best method” of installation based on lab testing and field
experience. It is at the discretion of the customer to choose how the installation will proceed. The
recommended installation of the flush mount sensors is very different from the recommended
installation of the surface mount. One commonality is the recommended epoxy/adhesive, named
SmartStud Adhesive, which can be purchased directly from Sensys Networks. MSDS records
can be found on our website at
www.sensysnetworks.com/msds.
NOTE: Test basic sensor functionality before installation. Reference Basic Functionality
Tests, in the VDS240 Wireless Vehicle Detection System Users Guide.
3.1 Label Location and Information
Each sensor will have a label attached on the top side. Use the label to determine sensor ID and
proper installation orientation. The label contains the following information:
• Serial Number
• Bar Code
•
• Sensys Networks Logo
• An arrow, parallel to the direction of traffic flow.
3.2 VSN240-F Install
Figure 1 VSN240-F Flush Mount Sensor