User's Manual

1608 4th Street Suite 200 Berkeley CA 94710
|
www.sensysnetworks.com/resources
|
P 510.548.4620 F 510.548.8264
Secure Bulkhead Connector to FlexNode Line Powered
Secure bulkhead connector to the FlexNode Line Powered bottom.
Assemble (cont.)
Quick Start Guide: FlexNode Line Powered Radio (NA)
Remove the cap from the TNC connector. Connect to one of the External
Antenna options with a coax cable. Two options are supported: (a) the FLEX-
ANT-1 with the same RF range as the internal antenna and (b) the FLEX-
ANT-2 with Long Range RF range. Point the external antenna towards the
sensors. The roles of the internal and external antenna can also be switched.
Connect External Antenna (Optional)
a
b
Carefully slide cover on top of FlexNode Line Powered over base. Cover will only be able to
fit one way, flip cover if it does not slide down completely. Insert retaining rods from the
rear side until rod head is flush against cover and the end of the rod fits into the receiving
hole. Insert reusable cotter pins into holes at the end of the retaining rods to lock in rods.
Note: Orient the flat rod heads on the same side of the cover with the raised rod hole ridges.
Slide Cover On and Secure Rods
Attach the FlexNode Line Powered to the mounting arm with
the Towards Sensors side facing the sensors and the access
point. Note that the mounting arm can be oriented to adjust the
location of the FlexNode Line Powered. The FlexNode Line
Powered can also operate with an optional external antenna.
Mount FlexNode Line Powered