User's Manual

1608 4th Street Suite 200 Berkeley CA 94710
|
www.sensysnetworks.com/resources
|
P 510.548.4620 F 510.548.8264
Assemble (cont.)
Quick Start Guide: FlexNode Line Powered Radio (NA)
Assemble bulkhead connector from the
FlexRepeat3 Line Powered onto the power cable.
Assemble Bulkhead Connector
Thread the power cable through the
repeater to reach the green terminal
block.
Thread Power Cable
Unplug the green terminal block from (a), then thread the stripped wires
into the green terminal block and tighten screws to t snuggly with a
small at head screw driver. The terminal block has NO POLARITY
requirement (either wire can go into either location). Plug the assembled
terminal block back into its original location.
Connect Stripped Wires to Green Terminal Block
Use a cable tie to attach the power cable to one of the metal prongs on the
FlexNode Line Powered to provide strain relief and trim off excess tie.
Note: The cable tie head must face inwards to allow assembly of the
FlexRepeat3 Line Powered cover.
Cable Strain Relief
a
Connect power cable to the power source. Wait approximately ve seconds
for LED lights to blink on the circuit board to ensure unit is turned on (a).
Connect to Power Source
a