Quick Start Guide

1608 4th Street Suite 200 Berkeley CA 94710
|
www.sensysnetworks.com/resources
|
P 510.548.4620 F 510.548.8264
Congure Repeater
Select a repeater from the image
map or tray to access the Repeater
Conguration window with the Info
tab open. The Name eld allows the
repeater’s name to be user-dened.
Note: Repeater’s rmware version is
displayed for reference only.
Repeater Conguration Window
5
Select an upstream channel by clicking
the Cong tab. Select an entry for the
Current Upstream Ch eld by clicking on
the Change to drop-down list.
Specifying Upstream Channel
Select a entry for the Current
Downstream Ch eld by clicking
the Change to drop-down list.
Specifying Downstream Channel
• The default radio channel
for access point to repeater
communications is 4.
• The default radio channel for
repeater to sensor communications
is 5.
• Never use the same channel for
both access point and sensor
communications.
Refer to Sensys Network VDS240
Wireless Vehicle Detection System
TracDOT Set Up and Operating
Guide for more information.
Channel Notes
• When an installation contains
multiple repeaters with more than
20 sensors, changing one or more
repeaters from Current Cong 0 to
Current Cong 1 allows the access
point to communicate with up to
40 sensors through the repeaters.
Refer to Sensys Network VDS240
Wireless Vehicle Detection System
TracDOT Set Up and Operating
Guide for more information.
Cong Notes
Quick Start Guide: FlexRepeat3 Solar Repeater