User manual
SENSUS
™
Pain Management User Manual
29
When I start a therapy session the light immediately blinks red.
Generally, a ashing red light indicates that the contact between
the electrode and the skin is inadequate. This may occur because
the device is not securely placed on the leg or because the
electrode is dry or damaged. Wait a few minutes and then restart
the therapy session. If this happens again then wait 15 minutes
and restart the therapy session. If the problem recurs, then
remove the device and inspect the electrode. If the gel is dry then
hydrate as described in Chapter 7. Place the device back on the
leg making sure that the entire electode is in contact with the
skin. Wait a few minutes and restart the therapy session.
Therapy:
The light is blinking green but I do not feel anything.
Wait until therapy has run for at least 2 minutes. If, after 2
minutes, you still cannot feel the stimulation, the intensity is too
low. Press and hold the button to increase the intensity until you
feel strong but comfortable stimulation. Alternatively, repeat the
conguration procedure.
Therapy stopped and the red light is blinking.
Generally, a ashing red light indicates that the contact between
the electrode and the skin in inadequate. This may occur because
the device is not securely placed on the leg or because the
electrode is dry or damaged. Wait a few minutes and then restart
the therapy session. If this happens again then wait 15 minutes
and restart the therapy session. If the problem recurs, then
remove the device and inspect the electrode. If the gel is dry then
hydrate as described in Chapter 7. Place the device back on the
leg making sure that the entire electrode is in contact with the
skin. Wait a few minutes and restart the therapy session.