User manual

SENSUS

™

Pain Management User Manual

Setting Continuous Mode

A device in continuous mode will restart therapy an hour after

your last session has completed. This may be convenient if you

choose to wear it during sleep or if you need extended pain

relief during the day. When you receive your device, continuous

mode is off. You may toggle the continuous mode from off to on

or vice versa. With the device in your hand, without an electrode

attached, press the button for at least 10 seconds, and you will

then see either a green or red light. A green light means you are

now in continuous mode; a red light means you are now out of

continuous mode (i.e., device is in single therapy session mode).

Notes about Continuous Mode

• The rst therapy session after toggling continuous mode to

on must be started manually. Press and hold the button until

indicator light starts blinking green.

• If you are in continuous mode but notice that therapy has not

restarted, you may initiate a session manually. There are a few

reasons a restart may not have occurred:

• Previous therapy session was halted by user

• Device was removed from the skin

• It has been less than an hour from the last therapy session

• Battery is low

• Even if you are in continuous mode, you can always start a

therapy session at any time. It is recommended that you wait at

least 30 minutes following the prior session.