User manual

SENSUS
™
Pain Management User Manual
17
Ending Therapy Session
A therapy session automatically stops
after 60 minutes. If the device is in
continuous mode, a new therapy
session will automatically start 60
minutes following the end of prior
session (see page 18 for explanation
of continuous mode).
You can end a therapy session early by
tapping the center compartment with
your hand twice, while keeping your leg still, as shown in Figure
14. You should not remove the device while it is stimulating, so
make sure that the indicator light is not blinking green before
removing the device and electrode from your leg.
After completing a therapy session, you may either leave the
device on your leg, or remove it. If you remove it, be careful not
to damage the electrode and remember to reapply the plastic
liner and store the device in the carrying case (see page 20 for
instructions on removing electrode).
If you leave the device on your leg for long periods of time, you
should check your skin frequently to make sure that it does not
get irritated. Chapter 8 provides information on skin care.
Ventilate your skin after wearing for several hours and after
overnight use. Refer to Chapter 8 for skin care.
If a problem arises during a therapy session, stimulation
will stop and the indicator light will blink red for 10 minutes.
Refer to Appendix B for troubleshooting assistance.
Figure 14.