User manual

SENSUS
™
Pain Management User Manual
12
A white label is
afxed to each
electrode liner
(Figure 9). The
rst time you use
a new electrode,
write the date
on the label. The
electrode should be replaced 2 weeks from this date (can
be extended up to 3 days if a new electrode is not available).
Device Placement
Place the device on your upper calf about
1-2 inches below the knee (Figure 10). Be
sure the electrode is only covering healthy
skin that is not irritated and does not have
cuts or other wounds. Position the device
so that it is comfortable, the button is
accessible, the indicator light is visible, and
stimulation does not cause discomfort. You
may position the device with the button on
the inside, outside, or back of the leg; it is your choice. However,
you should avoid placing the device on the front of the leg.
If the device cannot be placed in the standard location as shown
in Figure 10 then refer to Appendix D for alternate site options.
Loop the strap through the buckle and secure it with the Velcro
®
fastener as shown in Figure 11. The device should t securely
around your leg and be comfortable to wear. The strap should
not be so tight that the device and electrode substantially indent
the skin. The electrode should make smooth contact with the
skin. If there is buckling of the electrode, loosen the strap, smooth
the electrode and re-secure the strap. It is important that each
of the four electrode pads are in contact with your skin. If the
Figure 10.
Figure 8. Figure 9.